| Straight Quick Release Coupler | ||
| Special Composite Material for Heat & Fuel resistance. Also brass inserts that seal the ID of the tubing as well as the spring loaded "grasping" ring gripping the OD of the tubing. Good at well below 0 deg F to well over 200 deg. F. |
$ 6.85 ea. part # FC - 250180 |
|
|
|
||
| 90 Degree Quick Release Coupler |
|
|
| Special Composite Material for Heat & Fuel resistance. Also brass inserts that seal the ID of the tubing as well as the spring loaded "grasping" ring gripping the OD of the tubing. Good at well below 0 deg F to well over 200 deg. F. |
$ 7.45 ea. part # FC - 250090 |
|
|
|
||
| Low Restriction Brass Straight Push-Loc Fitting |
|
|
|
A quality barbed brass fitting for the typical Flo-Commander .170 ID tubing. These type are harder to find, (with the low restriction "hole" thru them). |
$ 2.87 ea. part # FC -S B170 |
|
|
|
||
| Filter/Diffuser | ||
| For direct mount |
$19.95 part # FCFD |
 |
| For tubing mount |
$19.95 part # FCFT |
|
|
|
||
| Universal Mounting Kit |
|
|
|
For custom set-ups
Bracket blanks, high quality hardware, 4 small tubing grommets, 4 each for two different thickness ranges, and one large grommet port plugs, and two sizes of adjuster access plugs, instructions. Military Spec Grommets, and high quality fasteners.
|
$29.95 part # FCB00K1 |
|
|
|
||
| "Jet Kit" Restrictor/Plug Removal Kit |
 |
|
| Several small drill
bits, a centering device, & the proper size extractor tool. You only need to remove plugs, if you have installed a Jet Kit, which required you to plug the main air circuit, that you will now be using again.
|
$13.95 part # FC-5K if ordered with F.C. Kit 10.95. Price will be adjusted in house. |
|
|
|
||
| Tubing Adapters |
 |
|
| (or ask about an exchange w/F.C.
Kit purchase) These are for the case where you have drilled and tapped your main air bleeds for replaceable jets. They are 5mm thread. We have them available for all applications though & they run between 21.95 & 28.95 per set of 4. |
$24.95 part # FC-A5K50 |
|
|
|
||
| Pod Filter Kit |
 |
|
|
This kit allows you install air-box type kit with individual Pod Filters. Includes Military Spec Grommets, bracket blanks, 1/4" bit, our high quality tubing, along with a length of less expensive "PRACTICE" tubing. |
$29.95 part # FC-PK4 |
|
|
|
||
| SPARE TUBING ROLL | ||
|
Specify Blue or Red in Comments line, we'll send red if you don`t specify. |
$6.99 part# TBG-40 |
|
